Sarge AI + Epoch Problems

[Hummuluis]

Hello all,

 

So I have a fresh Epoch 1.0.2.3 server setup, and have been working on getting Sarge AI installed. I have followed the directions listed, though I'm stuck on a restriction error from BattlEye.

 

Steps taken in order, as follows -

 

1. Under MPMissions > DayZ_Epoch_11.Chernarus, I created a new 'addons' folder and moved SHK-POS, SARGE, and UPSMON into the folder.

 

2. Edit init.sqf under MPMissions > DayZ_Epoch_11.Chernarus, nd add the provided lines at the very end.

 

3. Edit description.ext and add the provided line at the very end.

 

4. Use PBOViewer, and unpackaged dayz_server.pbo that's located under @DayZ_Epoch_Server > addons directory. Then make the provided changes to server_cleanup.fsm.

 

5. Didn't touch SAR_config.sqf since those were set to false already.

 

6. Edited scripts.txt under instance_11_Chernarus > BattlEye, and the lines provided were not listed there so I added both to this file.

 

Restarted the server, and everything goes smoothly until you get to Requesting Server Authentication, which now takes between 60-120 seconds to load which without these changes, it normally went through instantly. Once that finally loads through, I get a BattlEye Restriction #0 and am kicked.

 

Below is from the log, edited out the GUID and IP with xxxx.

 

- - -

 

21:00:04 BattlEye Server: Initialized (v1.177)
21:00:04 Host identity created.
21:00:42 Necro uses modified data file
21:00:42 BattlEye Server: Player #0 Necro (xxxx) connected
21:00:42 Player Necro connecting.
21:00:42 Mission DayZ Epoch Chernarus read from directory.
21:00:43 Player Necro connected (id=95305030).
21:00:43 BattlEye Server: Player #0 Necro - GUID: xxxx (unverified)
21:00:43 BattlEye Server: Verified GUID (xxxx) of player #0 Necro
21:00:46 Roles assigned.
21:00:46 Reading mission ...
21:00:54 Mission read.
21:01:39 Game started.
21:02:04 Player Necro kicked off by BattlEye: Script Restriction #0
21:02:04 Player Necro disconnected.
 

Thank you in advance. I'm sure it's something simple I'm missing or may have done incorrect. Server works fine without Sarge AI. Only breaks when I make the edits.

[Ephox]

Go to scripts.txt change the "1" from the first line to "5" the "1" should be the first letter. Example: if you get script restriction #8 go to line 10 of scripts.txt and change the 1 to 5. Scripts.txt is in the battleye folder.